Hamamatsu Photonics ORCA-Fire C16240-20UP Instruction Manual page 18

Digital CMOS Camera C16240-20UP / C16240-20UP01 Instruction manual_Ver.1.3
• When you connect cables, turn off the power supply of the camera and the peripheral devices.
• If you use the above options, see each installation manual.
AC adapter
This is the cord to supply a power supply. Use the accessory AC adapter.
CoaXPress interface cable 1 - 4 (Option)
These are the cables to connect the CoaXPress interface connector 1 to 4 of the camera and the
CoaXPress interface connector 1 to 4 on the computer, respectively.
•
•
•
USB interface cable (Option)
This is the cable to connect the USB interface connector of the camera and the USB interface connector
on the computer.
•
•
•
16
Place the camera the ventilation ports to be upward. Do not place the rear
•
panel of the camera, which connectors are located, to be at the bottom (Do
not block ventilation openings.).
When a connection interface is changed from CoaXPress to USB, and vice versa, the
application software must be closed and the camera must be turned off.
Do not connect CoaXPress and USB interface simultaneously.
Hamamatsu recommends A14590-05-40 optional CoaXPress interface cable for this
camera. The camera complies with EMC and FCC regulations with using A14590-05-40
CoaXPress interface cable. Be careful that the camera with other interface cable may not
fulfill the EMC and FCC directive requirements.
When a connection interface is changed from CoaXPress to USB, and vice versa, the
application software must be closed and the camera must be turned off.
Do not connect CoaXPress and USB interface simultaneously.
Hamamatsu recommends A12467-03 optional USB interface cable for this camera. The
camera complies with EMC and FCC regulations
with using A12467-03 USB interface cable. Be careful that the camera
with other interface cable may not fulfill the EMC and FCC directive requirements.