Viking VFR-500 Manual page 61

Program #32 Mode
1. Apply power to panel.
2. Press ENT to enter PROGRAM mode
3. Press 6 or scroll down to #6 and press ENT, (The selection is indicated by a flashing arrow next to the number.
4. Enter the password. (Factory default is 1111)
5. Press 1 or press ENT. (1 should be the highlighted selection)
6. The display shows the current program number. Press 32 to change to program 32. Press ENT.
7. Press 1 to accept the change.
8. Press ENT to accept the change.
Double Interlock with
Redundant Solenoids Cross
Zoned Activation
OUTPUTS
#1 GENERAL ALARM
#2 WATERFLOW ALARM
#3 RELEASE SOLENOID
#4 RELEASE SOLENOID
* Release Outputs which are Cross-Zoned need a Software Zone in order to work properly. The Software Zone Number will be dis-
played upon a release.
XX = Cross-Zoned
Inputs: 3 Supervisory zones, 2 Detection zones, 1 Waterflow zone, 1 Manual Release zone
Outputs: 1 General Alarm, 1 Waterflow, 2 Release Solenoids
Operation: Activation of any supervisory zone or Low Air Alarm zone will create a supervisory condition on the panel, no
outputs will activate
Activation of Conventional Detection zone 3 and/or 4 will activate General Alarm output 1
Activation of either Conventional Detection zone 3 OR 4 AND Low Air Alarm zone 5 will activate General
Alarm output 1 and Release Solenoid outputs 3 and 4.
Activation of Waterflow zone 6 will activate General alarm output 1 and Waterflow output 2.
Activation of Manual Release zone #7 will activate General Alarm output 1 and Release Solenoid outputs 3 and
4.
VFR-500 PROGRAM TEMPLATES • 5403799 • REV A • 9/23
CONVENTIONAL INPUT ZONES
#1 #2
Low Air Valve Tamper Conventional
Supervisory Detection
PROGRAM #32
#3 #4 #5
Conventional Low Air Alarm
Detection
X X
XX XX XX Either
Zones 3 &5
or 4&5
XX XX XX Either
Zones 3 &5
or 4&5
61
SOFTWARE ZONES
#6 #7 #8
Waterflow Manual Release Zone
Release Type
X X X
X
X XX*
X XX*
#9
Release Zone
Type
X
XX*
XX*