Chore-Time ATF PLUS Installation And Operator's Manual page 29

MODEL ATF™ PLUS Feeding System
6. There is not enough room between the feed hopper and the first feeder pan to attach and stretch the spring.
Install the spring in between the first and second pan after the hopper. Then route the cable back to the first
pan and attach to the feed tube cable assemblies, see figure 37.
7. Install two cable assemblies at each feed level tube (if the cable assemblies have not yet been installed). The
cable stop should be on the inside of the feed level tube and pulled up tight against the inside, See figure 14
(on page 17) and See figure 15 (on page 18).
8. Thread the cable assemblies through the holes on each side of the pan shield from the underside. Then clamp
to the master cable with a cable clamp, see figure 38.
NOTE: Before clamping the cable assemblies to the cable, make sure that:
a. The springs at each end of the cable are stretched approximately 14" (355.6
mm).
b.The feed level tubes are raised as high as possible.
c.The stop on the cable assemblies are pulled up against the inside of the feed level
tube.
MF1814C
Figure 37. Hopper End Spring Installation
Figure 38. Cable Assembly Installation
Feeder Line Assembly & Suspension
29