Connecting Cables; Connecting An Rs-232C Cable - Christie DWU1052 User Manual

4. Connecting cables

To superimpose two images onto one screen, the same image must be input to
the Main and Sub projectors. There are various methods to input the image to the
projectors. This chapter describes the ways of connecting the cables. Read this
chapter to find a method that meets your needs.
NOTE • If Simple Stack without an RS-232C connection is used, the Main and
Sub projectors described below do not exist. Main in this chapter is read as one
projector and Sub as the other projector.
• For details on the specifications of the input ports, refer to
your devices (Operating Guide
(Operating Guide -

4.1 Connecting an RS-232C cable

If using Intellectual Stack, connect an RS-232C cross cable between the
CONTROL ports on the Main and Sub projectors. ( 8 ) This connection is not
required if using Simple Stack.
NOTE • If the RS-232C cable connecting the two projectors operating in
Intellectual Stack is disconnected, the projectors will exit from Intellectual Stack
and start to operate individually. Intellectual Stack will not restart even if the
cable is reconnected. Follow the procedures below to restart Intellectual Stack.
(1) Do not operate the projectors for more than 10 seconds after disconnecting
the cable to allow the projectors to recognize the disconnection of the cable.
(2) Turn off both projectors and allow them to cool sufficiently.
(3) Reconnect the two projectors with the RS-232C cable and turn them on
again. Intellectual Stack will restart.
DWU1052/DHD1052
User's Manual - Instant Stack Guide
→
Setting
Technical)
up) and Connection to the
22
Connecting with
ports.
020-000856-01 Rev.1 (12-2015)
LIT MAN USR DWU/DHD1052 ISG