Table of Contents
Advertisement
3.5
Preparing the vehicle
3
After the vehicle has been positioned on the low-loader, the following preparations
must be carried out:
- Close hopper, set hopper transport safeguards (1).
- Position the non-slip mats under the screed across the whole width of the vehicle (2)
and lower the screed.
- Switch off the paver finisher.
- Attach and secure the protective hood (3) to the operating panel.
- Lower the roof and set the retainers (4) properly on both sides. (see section entitled
"Protective roof")
- Fold up the walkway plates of the screed and fasten on both sides using lashing
straps (5) and the existing retaining pins (6).
C 12.18 8
1
2
4
5
6
Advertisement
Table of Contents
