Table of Contents
Advertisement
When work is finished
- Run the paver finisher empty and stop it.
- Move the drive lever (1) to the central position, set preselector (2) to "0" and set the
speed adjuster (3) to minimum.
- Switch the auger (4), conveyor (5), tamper(o) (6), vibration (7) and levelling (8)
functions to "OFF".
- Lift the screed with switch (9).
- Insert the screed transport safeguard.
- Retract screed to basic width with switch (10).
Where applicable, completely extend the levelling cylinders using switch (11).
- Use switch (12) to close the hopper lids.
- Set the hopper transport safeguard.
- Switch the tampers(o) (6) on; while operating the tampers at a low speed, let any
material residues drop out.
- Switch tampers(o) (6) "OFF".
- Switch the screed heater system off. (See screed operating instructions)
- Switch the working and warning lights (13) to "OFF".
- Read and check the operating hour meter (14) to determine whether maintenance
work must be performed (see chapter F).
- Turn the engine off with switch (15).
- Remove the ignition key (16) in position "0".
- (o) Close main shut-off valve and the bottle valve of the screed gas
heating system.
- Remove the levelling units and stow them away in the boxes, close all flaps.
- Remove all parts that extend beyond the paver finisher contour or secure them
if the paver finisher is to be transported over public roads on a low-bed trailer.
m
Do not turn off main switch until 15 seconds after the ignition has been turned off!
The engine electronics need this length of time to back up data.
A
- Cover and lock the operating panel.
- Remove material residues from the screed and the paver finisher and spray all
parts with separator fluid.
D 42.18 27
Advertisement
Table of Contents
