Table of Contents
Advertisement
Drive belts
Checking / adjusting belt tension:
- The tension of the belt can only be adjusted using a pre-tensioning test device.
Checking belt tension
The tension of each belt must be
inspected with
ing instrument.
Specified tension:
- In case of initial assembly: 605-648N
- After running-in period /
maintenance interval: 518-561N
Instructions for checking tightness in the
A
pretention measuring instrument instructions.
A pretention measuring instrument can be ordered under Article No. 4753200045!
A
If necessary, adjust the belt tension:
- Unfasten lock nut (A) from the clamp-
ing lock.
- Adjust belt tension to the correct val-
ues by turning the clamping lock (B).
- Tighten the lock nut (A) again.
Further instructions for checking of ten-
A
sion - see description of the pre-tension-
ing test device.
A belt pre-tensioning test device can be
A
ordered from Dynapac as a spare part!
Item number on request.
F 83.18 10
a
pretension
check-
Riemensp.tif
A
B
Advertisement
Table of Contents
