Table of Contents
Advertisement
Loading/conveying material
- Use switch (1) to open the hopper.
Instruct the truck driver to dump the material.
- Set the switches for the auger (2) and the conveyor (3) to "auto".
The conveying function starts by deflecting the drive lever.
A
Check that the material is transferred properly.
A
Readjust the auger limit switches (A) if conveying is not satisfactory. Adjust the con-
veyor limit switches with the vehicle turned off until sufficient material is conveyed in
front of the screed.
Filling function
A
The "filling function" can additionally be used to convey the material in front of the
A
screed at the start of paving:
- Set the switches for the auger (2) and the conveyor (3) to "auto".
- Actuate switch (4):
The engine speed is increased, the conveying functions (conveyor and auger) are
switched on without deflecting the drive lever.
Once the set material height is reached at the limit switches, the conveying functions
A
are switched off.
D 42.18 20
Advertisement
Table of Contents
