Table of Contents
Advertisement
1.2
Preparation for transportation
- Use switch (1) to close the hopper.
- Engage both hopper transport safeguards.
- Lift the screed completely using switch (2), set the crossbeam lock.
- Turn the travel drive preselector (3) to zero.
- Fully extend the levelling cylinders with the switch (5).
To extend the levelling cylinders, levelling operating mode (6) must be switched
A
to "MANUAL" on the remote controls.
- Use switch (7) to adjust the screed to the basic width of the paver finisher.
m
Lift the auger if necessary!
If the engine is started with the drive lever pivoted out, the travel drive is inhibited.
A
To start the travel drive, first the drive lever must be returned to the centre position.
D 42.18 14
Advertisement
Table of Contents
