Table of Contents
Advertisement
After starting
To increase the engine speed:
- Increase the engine speed with switch (1).
The engine speed is increased to the preset value.
A
Let the paver finisher warm up for approx. 5 minutes if the engine is cold.
m
Observe indicator lamps
The following indicator lamps must be observed under all circumstances:
Battery charge indicator (2)
Must go out after starting.
m
If the lamp does not go out or lights up during operation: Briefly rev up the engine.
The engine speed can be increased by switching on a conveying function.
A
Switch off the engine and determine the fault if the lamp does not go out.
Error message (3)
Lights up for a few seconds once the ignition has been switched on for
A
checking purposes.
m
If the lamp does not go out or lights up during operation: switch off engine immediately
and determine fault.
Depending on the type of fault, the vehicle can temporarily continue to be operated
A
or, in the case of serious faults, should be shut down immediately to prevent further
damage from occurring.
Oil pressure indicator lamp for the diesel engine (4)
Must go out at the latest 15 seconds after starting.
m
If the lamp does not go out or lights up during operation: switch off engine immediately
and determine fault.
D 42.18 12
Advertisement
Table of Contents
