Table of Contents
Advertisement
2
Distribution auger
2.1
Height adjustment
V1
V2
Depending on the material, the height of the auger – measured from its lower edge –
should be at least 50 mm (2 inches) above the height of the material layer.
Example:
An incorrect height setting can result in the following problems during paving:
- Auger too high:
Too much material in front of the screed; material overflow. When operating with
larger working widths, demixing and traction problems may occur.
- Auger too low:
Not enough material that can be precompacted by the auger. Irregularities resulting
from this cannot be completely compensated by the screed (wavy surface).
In addition, increased auger segment wear occurs.
4
4
layer height 10 cm
adjustment 15 cm from the ground
2
1
1
2
3
3
E 10.18 3
Advertisement
Table of Contents
