Table of Contents
Advertisement
Pump distribution gear (5)
- Check the oil level at the sight
glass (A)
gear housing).
The oil level must be up to the centre of
A
the sight glass.
For filling with oil:
- Unscrew the filler screw (B).
- Fill oil in through the filling port until the
required filling level is achieved at the
sight glass (A).
- Screw in the filler screw (B) again.
m
Make sure to clean the screw and the vi-
cinity of the drain bore!
Oil change:
- Place the end of the oil drain port hose
(C) in the collection container.
- Remove the screw cap with a wrench
and allow the oil to drain completely.
- Replace the screw cap and tighten
properly.
- Fill in the oil of specified quality
through the filling port on the gearbox
(B) until the oil level rises to the centre
of the sight glass (A).
The oil should be changed when at oper-
A
ating temperature.
(at
the
side
of
the
A
B
C
F 60.18 11
Advertisement
Table of Contents
