Related Manuals for SHOWTEC STAGEBEAM MKII 2000W FRESNEL V1
Summary of Contents for SHOWTEC STAGEBEAM MKII 2000W FRESNEL V1
- Page 1 MANUAL ENGLISH Stagebeam MKII 2000W Fresnel Ordercode: 30730/30731 Highlite International B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands...
-
Page 2: Table Of Contents
Stagebeam MKII 2000W Fresnel Table of contents Warning ................................... 2 Safety Instructions ..............................2 Operating Determinations ............................4 Rigging ..................................4 Return Procedure ..............................6 Claims ..................................6 Description of the device ............................. 7 ... -
Page 3: Warning
Stagebeam MKII 2000W Fresnel Warning Unpacking Instructions Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all parts are present, and have been received in good condition. Notify the dealer immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. - Page 4 • If your Showtec device fails to work properly, discontinue the use immediately. Pack the unit securely (preferably in the original packing material), and return it to your Showtec dealer for service.
-
Page 5: Operating Determinations
Stagebeam MKII 2000W Fresnel Operating Determinations • This device is not designed for permanent operation. Consistent operation breaks will ensure that the device will serve you for a long time without defects. • The minimum distance between light output and the illuminated surface must be bigger than 3 meters. - Page 6 Stagebeam MKII 2000W Fresnel The Stagebeam can be mounted to any kind of truss with a clamp. Improper installation can cause serious injuries and/or damage of property! Connection with the mains Connect the device to the mains with the power-plug. Always check if the right color cable is connected to the right place.
-
Page 7: Return Procedure
Stagebeam MKII 2000W Fresnel Return Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled with a Return Authorization Number (RMA number). Products returned without an RMA number will be refused. Highlite will not accept the returned goods or any responsibility. Call Highlite 0031-455667723 or mail aftersales@highlite.nl and request an RMA prior to shipping the fixture. -
Page 8: Description Of The Device
Stagebeam MKII 2000W Fresnel Description of the device Features The Stagebeam MKII 2000W Fresnel is a spot effect with high output. It is equipped with a GX9.5 ceramic lamp socket, suitable for 2000W lamps. Input voltage: 230V AC, 50Hz ... -
Page 9: Installation
Damages caused by non-observance are not subject to warranty. Installing the Lamp The Showtec Stagebeam MKII 2000W Fresnel uses the GY16 GE lamp, 2000W (ordercode: 80805G); the GY16 Osram lamp, 2000W (ordercode: 80805O); the GY16 Philips lamp, 2000W (ordercode: 80805P) and the GY16 Sylvania, 2000W (ordercode: 80805S). -
Page 10: Adjusting The Beam Angle
Stagebeam MKII 2000W Fresnel Adjusting the Beam Angle 01) Turn the beam angle adjustment screw to the left or right to increase/decrease the beam angle. Fig. 03 Filter Frame Retaining Clip 01) Push the retaining clip sideways to open. 02) Insert the filter frame. 03) Release the retaining clip to close. -
Page 11: Set Up And Operation
Stagebeam MKII 2000W Fresnel Set Up and Operation Follow the directions below, as they pertain to your preferred operation mode. Before plugging the unit in, always make sure that the power supply matches the product specification voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa. Connect the device to the main power supply. -
Page 12: Troubleshooting
01) Power supply. Check if the unit is plugged into an appropriate power supply. 02) The lamp. Replace the lamp. See page 8 for installing the lamp. 03) The internal fuse. Return the device to your Showtec dealer. 04) If all appears to be O.K., plug the unit in again. -
Page 13: Product Specifications
Stagebeam MKII 2000W Fresnel Product Specifications Model: Showtec Stagebeam MKII 2000W Fresnel Input voltage: 230V AC, 50Hz Power consumption 2000W Dimensions: 425 x 325 x 400 mm (LxWxH) Weight: 6,8 kg Electro-mechanical effects: Light source: GY16 2000W lamp (not included) Lamp socket: GX9.5... -
Page 14: Dimensions
Stagebeam MKII 2000W Fresnel Dimensions Ordercode: 30730/30731... - Page 15 Stagebeam MKII 2000W Fresnel Ordercode: 30730/30731...
- Page 16 ©2017 Showtec...