ColorCue 2 AIR
Add a Chase Step to an Existing Chase
To add a chase step to a chase:
Press one or more FIXTURES buttons (26)–(31) to select the fixture(s) for which you want to add a step
to an existing chase. You can select multiple fixtures at the same time.
Press and hold down the RECORD button (36) for 3 seconds to enter programming mode. The LED on
the button starts blinking.
Press the USER CHASES button (24) to enter User Chase mode. The LED on the button lights up.
Press the COLORS/CHASES button (1)–(20) for which you want to edit the chase. The LED on the
button lights up.
Press the STEP+ (33) or the STEP- (34) button to select the step after which you want to add another
step.
Set the color in one of the following 3 ways:
●
Manual setup: See 6.3.1. Manual Mode on page 20 to set the color manually.
●
Preset color:
●
User color:
Press the RECORD button (36) to save the setting. The LEDs on all buttons blink 3 times.
Press and hold down the RECORD button (36) for 3 seconds to exit programming mode. The LED on
the button turns off.
Delete a Chase Step
To delete a chase step:
Press one or more FIXTURES buttons (26)–(31) to select the fixture(s) for which you want to delete a
step from an existing chase. You can select multiple fixtures at the same time.
Press and hold down the RECORD button (36) for 3 seconds to enter programming mode. The LED on
the button starts blinking.
Press the USER CHASES button (24) to enter User Chase mode. The LED on the button lights up.
Press the COLORS/CHASES button (1)–(20) which you want to edit. The LED on the button lights up.
Press the STEP+ (33) or the STEP- (34) button to select the step which you want to delete.
Press the DELETE button (37) to delete the step.
Press and hold down the RECORD button (36) for 3 seconds to exit programming mode. The LED on
the button turns off.
Delete a Chase
To delete a chase:
Press one or more FIXTURES buttons (26)–(31) to select the fixture(s) for which you want to delete a
user-recorded chase. You can select multiple fixtures at the same time.
Press and hold down the RECORD button (36) for 3 seconds to enter programming mode. The LED on
the button starts blinking.
Press the USER CHASES button (24) to enter User Chase mode. The LED on the button lights up.
Press the COLORS/CHASES button (1)–(20) which you want to edit. The LED on the button lights up.
Press the DELETE button (37) and the COLORS/CHASES buttons (1)–(20) at the same time, to delete
the chase. The LEDs on all buttons blink 3 times.
Press and hold down the RECORD button (36) for 3 seconds to exit programming mode. The LED on
the button turns off.
Factory Reset
You can delete all user-programmed colors and chases and set the fixture type to its default setting:
RGBWA-UV.
Press and hold down the RECORD button (36), the DELETE button (37) and the CLEAR button (38) at the
same time for 5 seconds to restore the default factory settings. The LEDs on all buttons blink 3 times.
Product code: 50708
See 6.3.2.1. Preset Colors Mode on page 20 to select one of the 20 preset colors.
See 6.3.2.2. User Colors Mode on page 21 to select one of the user-recorded
colors.
27