Table of Contents
Advertisement
ColorCue 2 AIR
Cancel a Selection
To cancel a selection in Static Colors mode and Chase mode:
●
Press the same COLORS/CHASES button (1)–(20) again. The LED on the button turns off.
●
Press another COLORS/CHASES button (1)–(20) to select a new color/chase. This cancels the current
selection and activates the new one. The LED on the selected button lights up.
Clear a Value
Press the CLEAR button (38) to clear any value set with the controls (J)–(O).
You can clear the color values, selected in Manual mode, as well as the chase direction, speed, fade
and strobe in Static Colors mode and Chase mode.
Switch Between Modes
To switch from Static Colors mode or Chase mode to Manual mode, you need to fetch the output values
of the colors.
Turn the controls (J)–(O) fully clockwise or counterclockwise to fetch the output values. When the output
values are fetched, you can further adjust the color intensity in Manual mode.
To switch from Manual mode to Static Colors mode or Chase mode (or between Static Colors mode and
Chase mode, press the respective MODES button (R).
Programming Mode
In this mode you can create a custom color or a chase and assign it to one of the 20 COLORS/CHASES
buttons (A). The stored user colors/chases can be played in User Color mode and User Chase mode. See
pages 21–23 for more information.
Record a Color
To record a color:
Press one or more FIXTURES buttons (26)–(31) to select the fixture(s) for which you want to record a
color. You can select multiple fixtures at the same time.
Note:
The color is recorded on the DMX channel corresponding to the LED fixture and cannot be selected
on a different channel/fixture. If you want to have the same color recorded for all fixtures, you need
to select all 6 fixtures in step 1 above.
Press and hold down the RECORD button (36) for 3 seconds to enter programming mode. The LED on
the button starts blinking.
Press the MANUAL/SETUP button (25) to enter manual mode. The LED on the button lights up.
Turn the controls (J)–(O) to select a color. The available colors are Red, Green, Blue, White, Amber
and UV.
Press the USER COLORS button (22). The LED on the button lights up.
Press the RECORD button (36) and one of the COLORS/CHASES buttons (1)–(20) at the same time, to
save the color and assign it to a button. The LED on the selected COLORS/CHASES button (1)–(20)
blinks 3 times.
Note:
Press a COLORS/CHASES button (1)–(20) to make sure that no color is assigned to it. If the LED on the
button lights up, the button is not free. Press and hold down the RECORD button (36) for 3 seconds to exit
the mode. The LED on the button turns off.
Product code: 50708
25
Advertisement
Table of Contents
