Table of Contents
Advertisement
ColorCue 2 AIR
Setup Options
You can use the device to control lighting fixtures in 2 ways:
●
with wired DMX:
●
with wireless DMX:
Wired DMX Setup
To connect the device in a wired DMX setup, follow the steps below:
Use a 3-pin DMX cable to connect the 3-pin DMX connector OUT (X) to the DMX IN connector of the
lighting fixture.
Connect the DMX OUT connector of the first lighting fixture to the DMX IN connector of the second
lighting fixture with a DMX cable.
Repeat step 2 to connect all lighting fixtures in a daisy-chain.
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last lighting fixture on
the data link.
Power the device. See 5.4. Connecting to Power Supply on page 17.
Switch on the device. See 5.5. Switching On on page 17.
Power the lighting fixtures.
Set the correct DMX starting addresses of the lighting fixtures. See 6.2.2.1. DMX Starting Addresses of
the Connected Fixtures on page 19.
Product code: 50708
6 lighting fixture with up to 6 channels (RGBWA-UV). See 5.3.1. Wired DMX
Setup on page 15.
Multiple lighting fixtures. See 5.3.2. Wireless DMX Setup on page 16.
15
Fig. 07
Advertisement
Table of Contents
