Function
Server Address
Port
Sub-Device ID
Step 4
Click Apply.
5.11.17 Switch
Background Information
After setting Switch, when an IPC is connected to the PoE port, the system automatically assigns the
IP address to the IPC according to the defined IP segment, and the NVR will automatically connect to
the IPC.
● Only models with PoE ports support this function.
● Do not connect the PoE port with a switch, otherwise it will cause connection failure.
● This function is enabled by default, and the IP segment start from 10.1.1.1. We recommend you
use the default setting.
● When connecting to a third-party IPC, make sure that the IPC supports ONVIF protocol and DHCP
is enabled.
Procedure
Step 1
Select Main Menu > NETWORK > Switch.
Step 2
Configure IP address, subnet mask, and default gateway..
Table 5-71 Register parameters
Description
Enter the IP address or domain name of the server that you want to
register to.
Enter the port of the server.
Enter the ID allocated by the server.
Figure 5-240 Switch
353
User's Manual