Starting The Generator; Stopping The Generator; Emergency Stop - Mase Generators IS 6.1 Use, Maintenance And Installation Manual

IS 6.1
4.3 S
TARTING THE GENERATOR
GB
Before starting the generator check that all the doors
is closed.
Before starting the generator ensure that all the
2 1
preliminary checks have been carried out.
Start
Press the ON/OFF pushbutton (ref.1) to turn on the
module.
Press and hold pressed the START pushbutton (ref.2) in
order to preheat the glow plugs (pre-starting) and then
start the engine. Release only when the engine is started,
paying attention to not exceed 5 seconds for each starting
attempt and doing a pause of about 30 seconds between
them.
OPEN
Repeated unsuccessful starting attempts may cause
excessive accumulation of water in the exhaust system
3
with possible serious damage
to the engine.
In case of have difficulty in starting the engine,
absolutely do not persist for a long tim e before first
having closed the seawater intake cock (Ref.3).
During the running-in period (the first 50 hours), do
not apply loads exceeding 70% of the rated power of
the generator.
4
For more detailed information, consult the manual
provi ded by the en gin e m anu fac ture r, whi ch
accompanies each generator.
4.4 S
TOPPING LHE GENERATOR
Stop the generator by pressing the STOP button on
the control panel (ref.1).
The generator can be stopped also by setting the switch
(ref.4) to the "OFF" position.
Before stopping the generator, it is advisable to run it
for a few minutes without drawing current in order to
allow gradual cooling of the engine and the alternator.
4.5 E
MERGENCY STOP
For an emergency stop of the generator, set the
emergency switch to OFF.
Pressing OFF on this switch, the
Once the causes that determined the need for an
module will completely turn off
emergency st op have been eliminate d, reset the
emergency switch to ON to return to the operating
conditions. Start the generator from the remote control
panel.
GB
- 31