Stulz S-Klima C7000 User Manual page 21

C7000 Advanced
.../EA raw data
.../EA raw data/D-ON
.../EA raw data/D-OUT
BA C7000 for EC Tower | EN | 01-2019 | 1000755
Info
The ".../EA raw data" menu displays the
number of configured sensors.
The "D-IN", "D-OUT", "A-IN", "A-OUT" sub-
menus have diagnostic purposes and display
the state of each digital and analog in and
outputs.
Inputs 1 to 4 are shown in the first line, inputs
5 to 8 are shown in the second line, etc.
The table below indicates what the displayed
values mean.
Display
D-IN 1
D-OUT 1
A-IN 0-4095
A-OUT 0-4095
*Exception: When the "dehumidification" func-
tion is carried out, the relay is not energized.
If the unit is assigned to a zone, the values of the zone that the unit is in are displayed
here. The first line indicates whether backup operation is activated for this zone as well
as the sequencing time of the zone, room temperature, room humidity, supply air tem-
perature and supply air humidity of the zone.
If the average value calculation function is deselected, these values correspond to the
measured unit values.
Using the data logger, it is possible to save measured values or average values (zone
values) calculated by the controller and have them displayed in the form of a graphical
curve so as to show the time course of these values.
Two different values can be recorded at the same time.
In this window, you can set the period of time which will be displayed. Further information
(type of measured value and clock rate) can be defined in the Config menu.
You can choose from 5 different periods of time: hours (this setting displays the last 3
hours), day, week, month and year.
The time period is displayed horizontally; a vertical dashed line marks the actual time.
Vertically, the range of the measured variables within the limit values (if this exists for this
type of value) is displayed. Two exterior dashed lines mark the limit values. An interior
dotted line marks the setpoint, if this is present. The course of the measured value is
displayed by a continuous line.
Note:
Before these values can be displayed, the recording must be activated in the Config menu.
If the unit is de-energized, the values of both data loggers are deleted. (However, the
control can be switched off by using the start/stop button without deleting the data loggers.)
Meaning
Voltage present ->
no alarm
Relay energized* ->
Components in operation
0-20 mA, 0-10 V corre-
sponding to sensor type
0-10 V
Zone
Statistics/data logger
.../EA raw data/A-IN
.../EA raw data/A-OUT
21