Indoor Unit (Setting By Uty-Rsr, Uty-Rhr) - Fujitsu AJ 126LELDH Series Design & Technical Manual

2-6. Indoor unit (setting by UTY-RSR, UTY-RHR)
CAUTION
This setting changes the function settings used to control the indoor unit according to the installa-
tion conditions. Incorrect settings can cause a product malfunction.
• After the power is turned on, perform the "Function setting" according to the installation conditions
using the remote controller.
• The settings may be selected between the following two: Function number or Setting number.
• Settings will not be changed if invalid numbers or setting numbers are selected.
• This function is not available on the slave units.
• Before starting the function setting, refer to the indoor unit installation manual and prepare for the
setting.
• For details on the function numbers and setting numbers, refer to the indoor unit installation manu-
al.
¢ Preparation
1. If multiple indoor units are connected to a single wired remote controller, set up the remote con-
troller address with "Automatic address setting".
2. Before turning on the power of indoor unit, reconfirm following items:
• Piping air tight test and vacuuming have been performed firmly.
• There is no wiring mistake.
3. Turn on the power of indoor units.
By turning on the power, the indoor units initialize EEV.
Breaker ON
Before proceeding the function setting, refer to the following section and perform necessary steps:
• "Entering setting mode"
2-6. Indoor unit (setting by UTY-RSR, UTY-RHR)
Example: When 4 indoor units are connected
Indoor unit
Simple remote controller
RC AD
on page 07-33
- (07-96) -
Indoor unit Indoor unit
0 0 0
RC AD RC AD
Indoor units
Indoor unit
0
RC AD
Indoor units
2. Function settings