Fujitsu AJ 126LELDH Series Design & Technical Manual page 575

¢ Dimensions
75
Front View
¢ Installation
• Connection pattern
NOTE: Connection pattern is different according to type of Indoor unit.
Floor/Ceiling type
All wall mounted type
• Pattern A
1. Connect the end of remote controller cable directly to the exclusive terminal block.
2. Set the DIP switch (SW1) to "2WIRE" on the PCB of the indoor unit.
NOTES:
• Layout of terminal block and PCB is varies depending on the type of indoor unit.
• Operation may fail if it is connected to the outdoor unit or the terminal block for power
supply.
2-10. Simple remote controller (With operation mode: UTY-RSR)
19
Side View
Indoor unit type
All cassette type
All duct type
All floor type
All ceiling type
Functional grounding
(If necessary)
Remote controller cable
(Non-polar)
30.0
Hole: 9 × 4.5
Hole: 6 × 4.5
Rear View
Connection pattern
Terminal block
Indoor unit PCB
Set the DIP switch
(SW1) to "2WIRE"
- (05-75) -
Unit: mm
30.0
23.0
Hole: 12.5 × 4.5
Pattern A
Pattern A
Pattern A
Pattern A
Pattern A
Pattern B
2. Control units