Fujitsu AJ 126LELDH Series Design & Technical Manual page 830

6. After adjusting the item number to "13" in Menu 2-F1 settings, press the START/STOP
ton to switch to the function setting screen.
Setting item selection screen
RELATED LINKS
"Indoor unit address setting"
"Refrigerant circuit address setting"
"Indoor unit function setting"
 Indoor unit address setting
NOTE: Perform this setting on the master remote controller.
1. While displaying the function setting screen, press the TEMP. "
lect the 2-wire remote controller address.
Function setting screen
2. Press the START/STOP
Example: Selecting the 2-wire remote
controller address
3. Press the TEMP. "
Function number
1-4. Address setting by remote controller
Item number
on page 07-34
on page 07-36
on page 07-97
button to switch to the function number setting.
/
" or TEMP. " " button to adjust the function number.
- (07-34) -
Function setting screen
" or TEMP. " " button to se-
Example: Selecting the 2-wire remote
controller address (002-01)
Function number
Function number
but-
/
1. System settings