Fujitsu AJ 126LELDH Series Design & Technical Manual page 845

Hide thumbs Also See for AJ 126LELDH Series:
Table of Contents

Advertisement

 Setting up each indoor unit
Setting must be performed on each indoor unit requiring address setting by repeating following pro-
cedures.
"Preparation"
on page 07-45
"Entering setting mode"
"Indoor unit address setting"
"Refrigerant circuit address setting"
"Completion of setting mode"
Indoor unit
01
 Resetting the power after setting up all indoor units
NOTES:
• If the reset is not performed, function cannot be read correctly.
• After all the functions have been set, the circuit breaker needs to be switched off for at least 2
minutes.
– After the 2 minutes has passed, power can be restored.
– The set function is stored in the PCB and will remain in memory even when the power of in-
door unit is turned off.
However setting function is effective after disconnecting the power supply and then recon-
necting it.
• Record the latest configuration of the indoor unit function setting on a label, and put the label on
the unit so it can be used for after-sales service operations.
1-4. Address setting by remote controller
on page 07-46
on page 07-46
on page 07-47
on page 07-48
Indoor unit
Indoor unit
00
0
01
01
0
01
02
0
Wired remote
controller
(Touch panel)
Indoor unit
Indoor unit
01
13
0
01
Wired remote
Wired remote
controller
controller
(Touch panel)
(Touch panel)
- (07-49) -
Indoor unit
14
0
01
15
0
1. System settings

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents