Fujitsu AJ 126LELDH Series Design & Technical Manual page 865

Hide thumbs Also See for AJ 126LELDH Series:

Table of Contents

With referring to

code number of the mode you want to set on the LED105.

Then, press the ENTER button (SW109) to confirm the mode you want to set.

Flashing of LED105 stops and lights a number, and the lit number on the LED104 starts to

Again, with referring to

display the code number of the function you want to set on the LED104.

Then, press the ENTER button (SW109) to confirm the function you want to set.

Flashing of LED104 stops and lights a number.

To set another function, press the ENTER button (SW109) in the completed state of current

setting. Then, repeat steps 4. and 5. to set each function.

After all necessary function settings are completed, press the ENTER button (SW109) in the

setting completed state shown in the previous step.

5 seconds after, even if the ENTER button (SW109) is not pressed, the LED105 starts to flash

automatically.

Then, press the MODE/EXIT button (SW107) to exit the function setting mode.

2-1. Setting on outdoor unit PCB

"Setting list"

on page 07-70, press the SELECT button (SW108) to display the

Example: To select switching between Forced stop and Emergency stop

"Setting list"

on page 07-70, press the SELECT button (SW108), and

Example: To select the Emergency stop function

2. Function settings

Show Quick Links

Chapters

Table of Contents