Fujitsu AJ 126LELDH Series Design & Technical Manual page 905

Function
Function
number
Installation
position 27
setting
Cool air
temperature 30
trigger
Heat air
temperature 31
trigger
Auto restart 40
Cool-air
43
prevention
External
46
control
Error report
47
target
2-10. Function details
Factory
Setting number
setting
00 Center
01 Right
02 Left
00 Standard
01 Adjust (1)
02 Adjust (2)
00 Standard
01 Adjust (1)
02 Adjust (2)
03 Adjust (3)
00 Enable
01 Disable
00 Super low
Follow the setting
01 on the remote
controller
00 Start/Stop
01 Emergency stop
02 Forced stop
00 All
Display only on
01 central remote
control
♦ Switch the airflow direction based on the installation
position of the 3D flow cassette.
Left
♦ Adjusts the cool air trigger temperature.
To make the trigger temperature lower than the
standard temperature, use setting "01".
To make the trigger temperature higher than the
standard temperature, use setting "02".
♦ Adjusts the heat air trigger temperature.
To make the trigger temperature 6 degrees C lower
than the standard temperature, use setting "01".
To make the trigger temperature 4 degrees C lower
than the standard temperature, use setting "02".
To make the trigger temperature higher than the
standard temperature, use setting "03".
Enables or disables automatic system restart after a
power outage.
NOTE: Auto restart is an emergency function such
as for power failure etc. Do not start and
stop the indoor unit by this function in
♦
normal operation.
Be sure to operate by the control unit,
converter or external input device.
♦
Restrains the cold airflow with making the airflow
lower when starting heating operation. To correspond
to the ventilation, set to "01".
♦ Allows an external controller to start or stop the
system, or to perform an emergency stop, or to
perform a forced stop.
• If an emergency stop is performed from an
external controller, same refrigerant system will
be disabled.
• If forced stop is set, indoor unit stops by the input
to the external input terminals, and Start/Stop by
a remote controller is restricted.
♦
Changes the target for reporting errors. Errors can
either be reported in all locations, or only on the wired
remote.
- (07-109) -
Details
Center Right
2. Function settings