Removing The Sensor Tray For Nvidia Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

Figure 244. Locking the GPU assembly handle
Next steps
1. Install the PSB cold plates.
2. Reconnect all the cable connectors on the PSB connected from PDB, system board and PDB2. For more information, see
Cabling diagram.
3. Install the system board
4. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
5. Install the lower brace
6. Reconnect all the cables onto the system board. For more information, see
7. Install the risers.
8. Install the storage tray
9. Install the VSB cables on the system
10. Follow the procedure listed in the

Removing the sensor tray for NVIDIA GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect the cables from the connector on the system board and the storage tray.
4. Remove the VSB from the system board
5. Remove the storage tray.
6. Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Remove lower brace cover.
9. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
10. Slide out the system board
11. Make sure to wear gloves for remove sensor tray to prevent hands touch sensor cables directly.
tray.
bracket.
.
board.
After working inside your
Safety
Before working inside your system
and keep it on the storage tray and no need to disconnect from the PDB2.
tray.
system.
instructions.
.
Installing and removing system components
Cabling diagram.
227