Table of Contents
Advertisement
Figure 132. Intrusion switch cabling diagram for NVIDIA GPU configurations
Table 72. Intrusion switch cable connections
From
RIO-INTRUSION_DET1 (Intrusion switch connector on
system board)
Next steps
1.
Install the riser 4A
for Intel GPU configurations or
2.
Install the turtle shell
3.
Install the cable
cover.
4. Follow the procedure listed in
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the riser 1A
for Intel GPU configurations or
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
on the DLC module 2.
After working inside your
Safety
Before working inside your
To
Intrusion Switch on the Storage tray
install the riser 4B
for NVIDIA GPU configurations.
system.
instructions.
system.
Remove the riser 1B
Installing and removing system components
for NVIDIA GPU configurations.
149
Advertisement
Table of Contents
