Table of Contents
Advertisement
Figure 42. Removing the drive backplane
Next steps
Replace the drive
backplane.
Installing the drive backplane for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the
drives.
4.
Remove the cable
cover.
5.
Remove the turtle
shell.
6. Observe and disconnect the drive backplane cables from the backplane and signal and power cables from the system board.
NOTE:
To avoid damaging the backplane, remove the disconnected backplane cables from the cable routing clips.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the slots on the drive backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tab clicks into place.
82
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
