Table of Contents
Advertisement
Figure 117. Lift the turtle shell
2. Remove the liquid cooling tubes with numbers naming 11 an 12.
3. Release the blue thumb holder and rotate the metallic gate away from the liquid cooling tray.
4. Ensure all four anti-tilt wires are in the locked position (outward position), and then using a Torx T30 screwdriver, loosen the
captive nuts on the processor heat sink module (PHM) in the order that is mentioned below:
a. Loosen the first nut three turns.
b. Loosen the nut diagonally opposite to the nut you loosened first.
c. Repeat the procedure for the remaining two nuts.
d. Return to the first nut and loosen it completely.
NOTE:
Ensure that the anti-tilt wires on the DLC module are in locked position when loosening the captive nuts.
5. Set the anti-tilt wires on the DLC module to the unlock position and lift the DLC module from the system.
Installing and removing system components
137
Advertisement
Table of Contents
