Table of Contents
Advertisement
Next steps
.
1.
Install the power supply units
2. Reconnect the cables connector on the PDB.
3.
Install the VSB cables on the
4. Reconnect the liquid cooling tubes to the Manifold for the connectors 6, 7, 8.
5.
Install the system board
6. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
7.
Install the lower brace
8. Reconnect all the cables onto the system board. For more information, see
9.
Install the
Risers.
10.
Install the Storage tray
11.
Install the VSB cables on the system
12. Follow the procedure listed in the
Removing the CBB cold plate module for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the storage
tray.
4.
Remove the
risers.
5.
Remove the VSB cables from the system
6. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling
diagram.
7.
Remove lower brace
cover.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
9.
Slide out the system board
Steps
1. Here is the orientation image for removal and installation sequence of liquid cooling tubes for processor, CBB, GPU cold
plates.
Figure 168. Removal and installation sequence of liquid cooling tubes for processor, CBB, GPU cold plates
2. Unplug the cold plate tubes numbering with 1 and 6 from the Manifold Liquid cooling.
180
Installing and removing system components
PDB.
tray.
cover.
.
board.
After working inside your
Safety
Before working inside your system
board.
tray.
system.
instructions.
.
Cabling
diagram.
Advertisement
Table of Contents
