Laac Gpu Dip Tray; Removing The Laac Gpu Dip Tray - Dell PowerEdge XE8640 Installation And Service Manual

LAAC GPU Dip tray

Removing the LAAC GPU Dip tray

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the front top cover.
5. Remove the cooling fan and fan cage
6. Remove the expansion card
7. Remove the memory modules.
8. Remove the heat sink.
9. Remove the processors.
10. Remove the OCP card (if
11. Remove the power supply units
12. Remove the VSB
13. Disconnect cables that are connected to the components.
14. Remove the system board
15. Remove the system board
Steps
1. Using a Phillips 2 screwdriver, loosen the two blue thumb screws on both side of the GPU assembly.
2. Hold the two blue thumb screws and rotate the GPU assembly toward rear of the system.
3. Lift the black latch and disconnect the GPU cable connecting on the NVlink baseboard.
Figure 113. Removing the GPU assembly and cable
4. Observe and disconnect the cables from the LAAC GPU Dip Tray connector from the PDB and backplane.
5. Unlock the two blue thumb screws on the LAAC GPU Dip tray and two blue thumb screws on the LAAC Radiator handles.
Rotate both the handles at an angle. Holding both the handles, lift GPU with LAAC assembly away from the chassis.
Safety instructions.
Before working inside your
assembly.
risers.
installed).
(PSU).
tray.
system.
Installing and removing system components 137