Installing The Sensor Tray For Nvidia Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

3. Tilt the sensor tray along the corner of the GPU 3 and remove the GPU sensor along the GPU 3, GPU 4, GPU 2 and GPU 1
respectively
Figure 248. Remove the sensor tray
4. Remove the sensor tray cable connector on the PDB.
5. Remove and lift the sensor tray from the GPU cold plate.
Next steps
Replace the sensor tray for NVIDIA

Installing the sensor tray for NVIDIA GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect the cables from the connector on the system board and the storage tray.
4. Remove the VSB from the system board
configurations.
Safety instructions.
Before working inside your system
and keep it on the storage tray and no need to disconnect from the PDB2.
.
Installing and removing system components 229