Storage Tray; Removing The Storage Tray For Intel Gpu Configurations - Dell PowerEdge XE9640 Installation And Service Manual

Storage tray

This is a service technician replaceable part only.

Removing the storage tray for Intel GPU configurations

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the cable cover.
4. Observe and disconnect the intrusion switch cable from the storage tray that is connected from the system board.
Disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from the connectors of the storage
tray and keep the cables away from the storage tray.
Steps
1. Using a Phillips 1 screwdriver, remove the screws on the drive cage.
2. Rotate the handle at an angle and slide the storage tray toward the front of the chassis.
3. Lift the storage tray out of the system.
NOTE: There is label to show the Storage tray lock and unlock on the left side of the chassis.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 67. Removing the storage tray
Next steps
Replace the storage tray for Intel GPU
Safety instructions.
Before working inside your
configurations.
system.
Installing and removing system components 99