Crimping The Ot Terminal - Huawei SmartACU2000B Series User Manual

SmartACU2000B smart array controller
User Manual (with PID modules, 800 V AC)
You can connect a peripheral cable to the smart array controller in common mode or through a
pipe based on site requirements.



5.3 Crimping the OT Terminal

Figure 5-5




Figure 5-5 Crimping an OT terminal
Issue 05 (2019-01-20)
The way of handling the bottom waterproof connector varies depending on the connection
method. For details, see
Cables to the cabinet interior are connected in the same way irrespective of which
connection method is used. The following uses common connection as an example.
shows how to crimp an OT terminal.
Avoid scratching the core wire when stripping a cable.
The cavity formed after the conductor crimp strip of the OT terminal is crimped must wrap
the core wires completely. The core wires must contact the OT terminal closely.
Wrap the wire crimping area with heat shrink tubing or PVC insulation tape. The
following figure uses heat shrink tubing as an example.
When using the heat gun, protect devices from being scorched.
Copyright © Huawei Technologies Co., Ltd.
5.1 Selecting a Connection
5 Electrical Connections
Method.
56