Installing The Lower Triple Clamp (250 Xcf-W Usa); Greasing The Steering Head Bearing - KTM 250 XCF-W USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
Installing the lower triple clamp
11.35
3 0 0 3
2 0 0 2
1 0 0 1

Greasing the steering head bearing

11.36
(250 XCF‑W USA)
x
–
Clean the bearing and sealing elements, check for damage, and grease.
Long-life grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
Info
Check whether the top steering head seal
–
Push up protective ring
500098-10
–
Position the upper triple clamp with the steering.
–
Mount and tighten screw
Guideline
Screw, top steering head
–
Position the clutch line, wiring harness and CDI control unit. Mount and tighten
screws .

Guideline
Remaining screws, chassis
500099-11
–
Install the front fender. (
–
Install the start number plate. (
–
Install the fork legs.
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check the cable harness, cable, brake and clutch line for free movement and free
laying.
–
Check the steering head bearing play. (
500103-10
x
(250 XCF‑W USA)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(250 EXC-F EU)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
p. 104)

and O-ring .
 
.

M20x1.5
M6
p. 47)
p. 48)
( p. 42)
x
.

M8 17 Nm
(12.5 lbf ft)
p. 40)
x ( p. 44)
( p. 46)
x
( p. 44)
x
x ( p. 45)
is correctly positioned.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
Loctite ® 243™
46