Removing The Fork Protector; Installing The Fork Protector - KTM 250 XCF-W USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the fork protector

11.30

Installing the fork protector

11.31
(250 XCF‑W USA)
–
Fully tighten screw
Guideline
Screw, top triple clamp
–
Fully tighten screw
Guideline
Screw, bottom triple clamp
500094-11
(250 EXC-F EU)
–
Fully tighten screw
Guideline
Screw, top triple clamp
–
Fully tighten screw
Guideline
Screw, bottom triple clamp
100023-10
–
Position brake caliper, mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable clip
–
Position the wiring harness.
–
Position the brake line. Put the clamp on, mount and tighten screws
–
Install the front wheel.
500093-11
x
–
Remove the fork legs. (
–
Remove screws
–
Remove the screws on the right fork leg. Remove the fork protector upwards.
500105-10
x
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
–
Install the fork legs.
500105-10
.

.

.

.

M8
.

( p. 65)
x
p. 42)
on the left fork leg. Remove the fork protector upwards.

M6
M6
( p. 42)
x
M8 17 Nm
(12.5 lbf ft)
M8 12 Nm
(8.9 lbf ft)
M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
.

25 Nm Loctite ® 243™
(18.4 lbf ft)
.

10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
43
.
