Installing The Lower Triple Clamp (Exc-F Eu, Exc-F Aus, Xcf-W) - KTM 250 EXC-F SIX DAYS EU Owner's Manual

Hide thumbs Also See for 250 EXC-F SIX DAYS EU:
Table of Contents

Advertisement

12
SERVICE WORK ON THE CHASSIS
12.13
Installing the lower triple clamp
(EXC‑F EU, EXC‑F AUS, XCF‑W)
x
Main work
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
Check whether the upper steering head seal
Slide on protective ring
B01605-10
Position the upper triple clamp with the handlebar.
Mount screw
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws
.
5
Guideline
Remaining screws, chassis
B01518-11
Position the fork legs.
Position bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
B01520-10
Tighten screws
Guideline
Screw, bottom triple clamp
B01521-10
Tighten screw
Guideline
Screw, top steering head
B01522-10
p. 128)
and O-ring
.
2
3
but do not tighten yet.
4
toward the front.
6
.
7
.
4
is correctly positioned.
1
M6
10 Nm (7.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
61

Advertisement

Table of Contents
loading

This manual is also suitable for:

250 exc-f eu250 exc-f aus250 xcf-w usa

Table of Contents