Installing The Fuel Tank - KTM 250 XCF-W USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Installing the fuel tank

x
11.94
Danger
Fire hazard Fuel can highly flammable.
–
Never fill up the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See specifications on filling up with fuel.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Avoid contact of the fuel with skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
–
Remove screw
–
Remove the tube from the fuel tank vent line.
600675-11
–
Pull both spoilers to the side of the radiator bracket
upward.
600677-10
–
Position the fuel tank and install the two spoilers to the side of the radiator fixing.
–
Make sure that no cables or Bowden cables are trapped or damaged.
600676-01
–
Mount the fuel tank vent hose.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
(250 EXC-F EU)
–
Position the horn with the horn bracket.
600675-10
with the collar sleeve.

with the collar sleeve.

M6
and take the fuel tank away

10 Nm (7.4 lbf ft)
72