12
SERVICE WORK ON THE CHASSIS
12.13
Installing the lower triple clamp
(EXC‑F EU/AU/BR, XCF‑W)
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the upper steering head seal
–
Slide on protective ring
B01605-10
–
Position the upper triple clamp with the handlebar.
–
Mount screw
–
Position the clutch line, wiring harness, and voltage regulator. Mount and tighten
screws
Guideline
Remaining screws, chassis
M00096-11
–
Position the fork legs.
Bleeder screws
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
M00172-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
L02470-10
–
Tighten screw
Guideline
Screw, top steering head
M00098-10
p. 122)
and O-ring
but do not tighten yet.
.
face forward.
.
.
is correctly positioned.
.
M6
10 Nm (7.4 lbf ft)
M8
15 Nm
(11.1 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
54