Service Schedule; Important Maintenance Work To Be Carried Out By An Authorized Ktm Workshop - KTM 250 XCF-W USA 2010 Owner's Manual

SERVICE SCHEDULE

Important maintenance work to be carried out by an authorized KTM workshop.

10.1
Engine
Change the engine oil and oil filter, clean the oil screen.
Replace the spark plug.
Check the valve clearance.
Check the engine mounting screws for tightness.
Clean the spark plug connectors and check for tightness.
Check that the screws in the shift lever and the kickstarter are tight.
Carburetor Check the carburetor connection boots for cracks and leakage.
Check the vent hoses for damage and routing without sharp bends.
Check the idle.
Attachments Check the cooling system for leakage.
Check the antifreeze and coolant level. (
Check the exhaust system for leakage and looseness.
Check the Bowden cables for damage, smooth operation and routing without sharp
bends.
Check the fluid level of the hydraulic clutch. (
Clean the air filter.
Check the cables for damage and routing without sharp bends.
Check the functioning of the electrical equipment.
Check the headlamp setting.
Brakes Check the front brake linings. (
Check the rear brake linings. (
Check the brake discs. (
Check the brake fluid level of the front brake. (
Check the brake fluid level of the rear brake. (
Check the brake lines for damage and leakage.
Check the free travel of the hand brake lever. (
Check the free travel of the foot brake lever. (
Check the brake system function.
Check the screws and guide bolts of the rake system for tightness.
Chassis Check the shock absorber and fork for leakage and functioning.
Clean dust boots of fork legs. (
Bleed fork legs. (
Check the swingarm bearing.
Check the steering head bearing play. (
Check all screws to see if they are tight.
Wheels Check the spoke tension. (
Check the rim run-out.
Check the tire condition. (
Check the tire air pressure. (
Check the chain wear. (
Check the chain tension. (
Clean the chain. (
Check the wheel bearing for play.
Clean and grease the adjusting screws of the chain adjuster.
S3N: once after three operating hours
S20A: every 20 service hours / after every race
S30A: every 30 service hours
x
p. 73)
( p. 77)
x
p. 59)
p. 62)
p. 56)
p. 39)
p. 39)
p. 40)
p. 68)
p. 67)
p. 68)
p. 52)
p. 51)
p. 51)
( p. 79)
x
p. 55)
p. 57)
p. 61)
p. 56)
p. 61)
x
30
S3N S20A S30A
• •
•
• •
• •
• •
• •
•
• •
• •
• •
• •
•
• •
• •
• •
•
• •
•
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
•
•
•
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •
• •