Changing The Front Brake Linings - KTM 250 XCF-W USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Changing the front brake linings

11.70
Warning
Skin irritations Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will
be pleased to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
–
Fit the brake pads, insert bolt
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable clip
–
Operate the hand brake lever repeatedly until the brake linings lie on the brake disc
and there is a tight spot.
500089-12
x
–
Remove the front brake linings.
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
–
Install the front brake linings.
–
Add brake fluid to level
Guideline
Measurement of
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
600706-10
, and mount locking split pins

M8
.

( p. 59)
x
.

with membrane .
 
( p. 59)
x
.

5 mm (0.2 in)

p. 102)
.

.

25 Nm Loctite ® 243™
(18.4 lbf ft)
60