Table of Contents
Advertisement
Error Condition / Description / Corrective Action
Temperature Out of Range
Either the temperature zone is 2 degrees over the set point, or the temperature zone has
been disabled.
Corrective Action:
From the User Interface, check the Temperature Measure (Meas) and Setpoint (Set) values
to see if the Meas value is =/> the Set value. Refer to "Starting the ta7000F in the Warm-Up
Cycle" in Chapter 2.
FID Flame Out Error
The Flame Ionization Detector (FID) flame has gone out. Hydrogen or air mixture may be
incorrectly set.
Corrective Action:
Check the support gases, and then perform the Warm-up procedure. Refer to "Starting the
ta7000F in the Warm-Up Cycle" in Chapter 2.
FID Flame Ignition Error
The Warm-Up Cycle could not ignite the FID flame. Check the support gases then try the
Warm-Up Cycle again.
Corrective Action:
Check the support gases, and then perform the Warm-up procedure. Refer to "Starting the
ta7000F in the Warm-Up Cycle" in Chapter 2.
Carrier Pressure Out of Range
External carrier pressure is not within specified limits.
Corrective Action:
• Verify the external carrier pressure supply.
• Check the Carrier Gas requirements in the Specifications chapter, and check the Carrier Gas
• Adjust the pressure if necessary.
Analog Signal Zeroing Error
The instrument has failed to Zero the detectors analog signal.
Corrective Action:
Contact AMETEK Service or qualified service representative for troubleshooting assistance.
Calib Pressure Out of Range
Calibration gas pressure is not within normal operating range.
Corrective Action:
• Check the Calibration Gas requirements in the Specifications chapter, and check the Cali-
• Adjust the pressure if necessary.
4-2 | ta7000F Gas Purity Monitor
tank to ensure there is an adequate supply.
bration Gas tank to ensure there is an adequate supply.
PN T900-014, Rev B
Advertisement
Table of Contents
