Starting The Calibrator; Selecting The Set-Temperature - Ametek MTC-140 A User Manual

Connection for RS232 cable.
Note that all PC-equipment, which are connected to the
calibrator must observe the directive IEC950.
4.2

Starting the calibrator

Switch the calibrator on using the power control switch (pos.
1 in Fig. 6).
The instrument is initialised and the last calibration date is
displayed:
The calibration date will be displayed for approx. 2 seconds.
The initialisation process has been completed and the
calibrator is ready for use.
All settings are stored when the calibrator is switched off.
When the instrument is switched back on again, the status will
be the same as when it was switched off.
4.3

Selecting the set-temperature

Press
The current selection flashes in the bottom display:
The starting point is the last chosen set-temperature (even if
the instrument has been switched off).
20
or to adjust the set-temperature.
°C
°C
26-07-2004 105337 02