Controls - OREC HR662 Instruction Manual

DRIVING CLUTCH LEVER
Push the lever(1, Figure 1) down to the handlebar to make the
machine moving. Release the lever, then the machine stops.
BLADE CLUTCH LEVER
Blade clutch lever makes the engine drive the blade to
mow.Press the lever (2,Figure 1) then pull the lever (3,Figure
1) to make the blade turning.
Release the lever, then the rotor stops.
Never try to start or stop the engine with blade engaged
THROTTLE LEVER
Push the throttle lever(4, Figure 1) to left to increase engine speed, push the throttle lever to right to
decrease engine speed to idle rpm. Always operate mower at full engine speed.
SIDE CLUTCH LEVERS
The side clutch levers (5, Figure 1) are used to change the direction of the machine. Press right lever
to turn right and left lever to turn left. To move the machine when engine is cut off, press the both
levers.
Do not press the two levers in slopes when engine is running.
HANDLEBAR ADJUSTMENT LEVERS
Grip the lever ( 6, Figure1) to move handelbar right and left.
And grip the lever ( 7, Figure 1) to move handlebar up/dpwn.
SPEED LEVER
This lever (Figure 2) allows to select 3 forward speeds (1, 2, 3), 1
reverse speed (R) or 3 neutral location (N).
Operate speed and range lever only with the machine stopped
and engine at idle speed.
(1, F
CHOKE LEVER
IGURE
Push the lever to 2 to operate the choke to start engine cold, when
engine has start release it to 3.
Do not use the choke when the engine is hot

CONTROLS

WARNING
WARNING
3)
IMPORTANT
4
6
DANGER
2
5
1
3
7
Figure 1
Figure 2
2
Figure 3
3
1