Controls - OREC FL 500 Instruction Manual

DRIVING LEVER (1,
Push the lever forward to the handlebar 1, figure 2 to make the
machine moving. Release the lever, then the machine stops.
S (2, F
PEED LEVER IGURE
The lever allowed to select the speed ratio needed. The
machine offer 3 forward speed (1, 2, 3) and, 1 reverse speed
(R).
In the case of changing speed, travel lever must be released (OFF).
D L
IFFERENCIAL OCK LEVER
Push the lever forward to drive the rear wheel together in slipping condition.
Throttle lever and Choke lever (4, figure 2)
Push the lever completely forward to operate the choke to start cold engine, when engine has start
release it. Push the throttle lever forward to « HI » to increase
engine speed, pull the throttle lever rearward to « LO » to decrease
engine speed to idle rpm. Always operate mower at full engine
speed.
Do not use the choke when the engine is hot, it did not start
C
UTTING BLADE CLUTCH LEVER
Cutting blade Clutch lever make the engine drive the blade to mow.
Push the 2 action lever (6, figure 2), then pull the blade clutch lever
(5, figure 2) rearward to the handlebar to make the blade turning.
Release the lever, then the blade stops.
Never try to start or stop the engine with blade engaged.
FUEL COCK
The fuel cock (1, Figure 3) is closed when machine is not use. Fuel
cock is closed pushed rearward and open pushed forward.
HEIGHT OF CUT CONTROL
Height of cut can be setted by turning the crank-lever 1 Figure 4,
clockwise to increase the height of cut and anti- clockwise decrease
the height of cut.
Always perform this adjustment engine off and sparking plug
When cutting in low position, power needed and thrown objects are more important. Cutting
OREC FL500A - © SAT 03/03
2)
FIGURE
2)
Never change speed while driving.
(3, F 2,)
IGURE
Never turn the machine with the differential locked.
IMPORTANT
WARNING
WARNING
cover unplug
low can cause damage to the machine and injury.

CONTROLS

8
３
１
２
Figure 2
Figure 3
Figure 4
６
５
４