Controls - OREC RM83G Instruction Manual

« RM83G »
1
S
PEED CONTROL LEVER
This lever (1,Fig 5a) is used for running of this unit, stop operation, running direction and speed
adjustment.
Shifting is R "reverse" , N "neutral" , "Advance" has four stages of speed of 1, 2, 3, and 4. The speed
changes in the order of "low speed" 1→ 2 → 3 → 4 "high speed". 4th gear is for only moving, so
please DO NOT use it for mowing work. The speed is too fast and unsuitable to work. Switch to
forward / reverse after the machine has completely stopped.
If you switch it while driving, the transmission mechanism will be damaged.
S
PEED CONTROL LEVER
This lever (2, Fig 5b) is used to go forward, reverses and stop the machine. When the lever is placed
rear to « R » the machine is going on reverse. When lever is placed in front of « N » to « F » the
machine is going forward. When lever is placed in « N » position the machine is stopped.
Travel speed is increased by push the lever from « N » to « F » or « R ». Travel speed is decreased
by push the lever from « F » or « R » to « N ».
Push or release lever gradually (except on an emergency) to avoid sudden stop and go.
T
HROTTLE LEVER
Push the throttle lever (3,Fig 5a,b) forward to increase engine speed, pull the throttle lever rearward to
decrease engine speed to idle rpm. Always operate mower at full engine speed.
C
HOKE
Push the throtle lever completely to the front to activate the choke to start cold engine, and release it
gradually when engine become hot.
D
IFFERENTIAL LOCKING LEVER
This lever(4, Figure 5a,b) allows the rear wheels to be driven together in slipping areas. Apply the diff lock lever
when one wheel is slipping in straight line. Release the lever as soon as the machine leaves the slipping area.
The diff lock shoud be used in straight line only : never use the diff lock lever when turning. The
damage to the transmission will not be covered by the warranty
OREC RM83G - © SAT 03/2015
Figure 5a
(4 G ) <<RM83G>>
SPEED EAR
(HST) <<RM830>>

CONTROLS

4
3
9
« RM830 »
Figure 5b
2