Table of Contents
Advertisement
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
1
Display the screen.
1
[System Menu / Counter]key > [User Login/Job Accounting]
NOTE
If the user authentication screen appears, enter your login user name and login password and select [Login].
For this, you need to log in with administrator privileges.
The factory default login user name and login password are set as shown below.
Login User Name
d-COPIA 255MF:2500
Login Password
d-COPIA 255MF:2500
2
[User Login Settings] > [Obtain NW User Property] > [On]
2
Configure the settings.
Add information on each item > [OK]
Item
*1
Server Name
Port
*2
Name 1
*3
Name 2
*4
E-mail Address
Authentication Type
Search Timeout
LDAP Security (User
Property)
*1 If your Windows Active Directory is being used, the server name may be the same as the server name entered for network
authentication.
*2 If Windows Active Directory is being used, this normally uses the attribute's displayName.
*3 Name 2 can be left out. When you assign displayName in "Name 1" and department in "Name 2", and if the value of dis-
playName is "Mike Smith" and the value of department is "Sales" in Active Directory of Windows, the user name appears
as "Mike Smith Sales".
*4 If using Windows Active Directory is being used, the attribute's mail is normally used.
*5 Appears when the server type is set to "Kerberos" in "Network Authentication".
Enter the LDAP server name or the IP address (up to 64 characters). If a server name is not
entered, user information will be acquired from the server set for Network Authentication.
Port number for LDAP server. The default port number is 389.
Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server (up to
32 characters).
Enter the LDAP Attribute to obtain the E-mail address from the LDAP server (up to 128
characters).
*5
Set the authentication method. Select [Simple] or [SASL]. After changing the setting, restart
the system or turn the power off and then on.
Set the amount of time to wait before time-out in seconds (from 5 to 255 seconds).
Select the type of encryption according to the type of security employed by the LDAP server.
The value is [Off], [SSL/TLS] or [STARTTLS].
Description
9-21
Advertisement
Table of Contents
