Switching On The Meter; Setting The Date And Time - Xylem SI Analytics HandyLab 200 Operating Manual

Commissioning
14
Caution
Make sure that the poles of the batteries are positioned correctly.
The ± signs on the batteries must correspond to the
battery compartment.
Note
Alternatively, you can also use Ni-MH rechargeable batteries (type
Mignon AA). In order to charge the batteries, an external charging
device is required.
3 Place four batteries (type Mignon AA) in the battery compart-
ment.
4 Close the battery compartment.

3.2.2 Switching on the meter

1 Press the <On/Off> key.
The meter performs a self-test.
The display shows the manufacturer's logo while the self-test
is being performed.
Subsequently, the meter switches to the measuring mode
(measured value display).
Note
The meter has an energy saving feature to avoid unnecessary battery
depletion.
The energy saving feature switches off the meter if no key is pressed
during the adjusted interval. (How to set the switch-off interval, see sec-
tion 4.3.1).

3.2.3 Setting the date and time

1 See section 4.2.4
HandyLab 200
±
signs in the
ba77063e03 01/2018