Shure DCS 6000 User Manual page 36

DIS Digital Conference System
16.
# Menu
17.
36
Settings
User Manual CU 6110 rev A.docx
User Manual
Description
The 'Source' can be selected for
Audio Output –
each of the eight outputs (the
graphics is only showing four of the
eight outputs). The choices using
the dropdown menu are:
Group, Floor, Floor 1, Floor 2 or any
of the interpreter channels.
When 'Group' is selected for 'Out A',
the 'Group A' is the source and
similar for the three other outputs.
The 'Floor or Interpreter Channel'
selection is used either
recording of the interpreted
languages or for connection to a
wireless language distribution
system.
The 'Floor 1 or Floor 2' selection is
used when connection to external
PA system.
If 'Floor, Floor 1, Floor 2 or any of
the interpreter channels' is selected
for an output (Out A, B, C, D, E, F, G
or H) the corresponding group is
disabled in the 'Group Setup'.
The 'Audio Out Volume' can be set
for each of the eight audio outputs
(A, B, C, D, E, F, G and H).
The Conference units
Group Setup –
assigned individually
groups (the graphics
showing four of the eight groups).
'Group A' is always used as the
source to the built-in loudspeakers.
A unit can be selected in 'Group A'
and/or in one of the other three
groups. If a unit is not selected in
'Group A' the audio from this unit
cannot be available in the built-in
loudspeakers.
The 'Group' facility is used if
separate microphones are required
to be recorded or if external
equalization or volume control is
required.
Note: A microphone can only be
present in 'Group A' and in one
other group.
for
can be
to eight
is only