Shure DCS 6000 User Manual page 35

DIS Digital Conference System
13.
# Menu
14.
15.
Settings
User Manual CU 6110 rev A.docx
User Manual
Description
When the reset button is activated,
Reset to Factory Defaults –
the settings in the CU 6110 are reset
to factory default.
When doing this from a browser,
the IP and security settings aren't
changed.
To reset IP settings and security
settings, use 'Factory defaults' on
the interactive menu on the CU
6110.
Loudspeaker Control –
The 'Loudspeaker Volume' is setting
the volume of the
loudspeakers in the Conference
units.
The Gain of 'Audio In 1 & 2' can be
Input Control –
set to '0 dB' or '10 dB'. When set to
'10 dB' the input signal is amplified
10 db.
The 'Audio In 1 & 2 Volume' is used
to set the volume of the input signal.
'Audio In 1 & 2' can be routed to the
'Loudspeakers',
(headphones) in the Conference
units as well as to 'Out. A' output
using the selection buttons.
'Audio In 1 or 2' will only be present
at 'Out. A' if 'Group' is selected as
the source to the 'Out A' output,
where it will be mixed with the
'Group A' signal. See next menu
point.
The audio from the conference
microphones, which are selected in
'Group A' can be routed to the
Loudspeaker and/or Floor.
built-in
'Floor'
35